|Folding Kayaks Forum
|Page 1 of 1|
|Author:||Ozpaddler [ Fri Sep 28, 2018 10:10 pm ]|
|Post subject:||nautiraid rudder|
I don't think this has been covered, but on a recent trip the rudder connection on my nautiraid raid 2 came loose where the hypalon strips attach to the hull. Unfortunately I was a bit jet lagged at the time and have managed to lose the pieces of hypalon and the pin, but still have the rudder. I'm looking for advice on reattaching the rudder. I was thinking of using a couple of hypalon patches to attach a thin stainless steel tube to the hull, which I could then insert a new pin through that would be attached to the rudder. Any thoughts, or has anyone else had to do a similar job?
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group