Yet another method to attach floorboards in a Yost kayak

Discussion of user-built folding kayaks

Moderators: mje, chrstjrn, krudave

Post Reply
MrPorcine

Yet another method to attach floorboards in a Yost kayak

Post by MrPorcine »

The aim here is to reduce loose parts and make assembly go a little quicker.

I've permanently screwed the U-section to the L-bracket, then use a clevis with a spring-loaded ball to attach the whole assembly to the HDPE crossframes. Here are pictures:
floortop.JPG
FloorBottom.JPG
I used flat head SS 10-24 screws to attach the U-section to the L-bracket. A 3/8" drill and countersink just barely do the job without breaking out. Note that these L-brackets have SS rivenuts installed. A normal elastic stop nut will work just a well and is less expensive. Before I went to the clevis pins I was using 10-32 screws in each of the 8 places. The rivenuts were an attempt to minimize the loose parts. Actually the 8 SS screws worked pretty well. I found an electric screwdriver at Wal Mart that took 4 normal AA batteries. I just threw the screwdriver in the bag with the boat. I figured that I could find AA batteries anywhere. Still, the clevis pin method eliminates 8 loose pieces, 9 if you count the screwdriver.

It appears that one can only attach 3 pictures per message, I'll continue below.
complete.JPG
You do not have the required permissions to view the files attached to this post.

Post Reply

Return to “Homemade Folding Kayaks”